User manual

Zooming

When a compatible EF Cinema lens (A 222) is attached to the camera, you can use the joystick on the grip

unit to operate the zoom. You can also zoom remotely using Browser Remote on a connected Wi-Fi device

(A 123, 131).

Required settings on EF Cinema lenses

To operate the zoom from the camera, you will need to enable automatic adjustment using the controls on the

lens. Required settings vary depending on the lens. Refer to the following table and the instruction manual of the

lens used.

1 Enable automatic zoom adjustment on the lens.

2 Open the zoom’s [Activate] submenu.

[v Camera Setup] > [Camera Grip Zoom] > [Activate]

3 Select [On] and then press SET.

4 Open the zoom’s [Speed] submenu.

[v Camera Setup] > [Camera Grip Zoom] > [Speed]

5 Select the desired zoom speed and then press SET.

• Zoom speeds are constant; [1] being the slowest and [16] the

fastest.

6 Close the menu and use the joystick on the grip unit to

zoom.

• Push the joystick up to zoom in (telephoto) and push it down to

zoom out (wide-angle).

NOTESNOTES

• When an optional RC-V100 Remote Controller is connected to

the camera and the lens is correctly set, you can zoom with the

remote controller’s ZOOM dial.

• When using slow zoom speeds, it may take longer for the lens to

start moving.

Lens Part used on the lens Setting for automatic adjustment

CN7x17 KAS S/E1

CN20x50 IAS H/E1

Zoom operation change-over knob SERVO

CN-E18-80mm T4.4 L IS KAS S,

CN-E70-200mm T4.4 L IS KAS S

Zoom change-over switch SERVO

Operating modes:

[v Camera Setup]

[Camera Grip Zoom]

[Activate] ….. [Off]

[Speed] ….. [8]