User manual

Setting the Time Code
94
About the Time Code Display
An icon may appear next to the time code depending on the operation. Refer to the following table.
NOTESNOTES
• The frames value of the time code runs from 0 to 23 (frame rate set to 23.98P or 24.00P), from 0 to 24 (frame
rate set to 25.00P, 50.00i or 50.00P), or from 0 to 29 (all other frame rates).
• When you are using interval recording or frame recording, you cannot select the [Free Run] running mode.
Conversely, when you are using pre-recording mode, [Free Run] is set automatically and cannot be changed.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• When you are using the [Free Run] running mode, the time code will continue running as long as the lithium
button battery has some charge left, even if you disconnect all other power sources.
• If you set an assignable button to [Time Code] (A 135), you can press the button to open the
[¢ Picture/Terminals Setup] > [Time Code] submenu.
Icon Description
R The time code mode is set to [Regen.].
P The time code mode is set to [Preset] and the running mode is set to [Rec Run].
F The time code mode is set to [Preset] and the running mode is set to [Free Run].
E Time code signal is coming from an external source.
H Time code display is on hold.
No icon Time code during clip playback.