Operation Manual

117
Special Recording Modes
Interval Recording Mode
Set the interval and number of frames in advance. Sound is not recorded
in this mode.
Activating and Configuring
1 Open the [Recording Mode] submenu.
[3 Recording/Media Setup] > [Recording Mode]
2 Select [Interval Recording] and then press SET.
[INT STBY] appears at the top of the screen (with [INT] flashing).
3 Open the [Interval] submenu.
[3 Recording/Media Setup] > [Special Recording Settings] >
[Interval Recording] > [Interval]
4 Select the desired interval and then press SET.
You can select one of 12 interval settings from 1 second to 10
minutes.
5 To set the number of frames to record, open the [Recorded Frames]
submenu.
[3 Recording/Media Setup] > [Special Recording Settings] > [Interval Recording] > [Recorded Frames]
6 Select the desired number of frames and then press SET.
Available options are 1, 3, 6 and 9 frames.
Recording
1 Press the START/STOP button to begin recording.
The camera automatically records the set number of frames at the specified interval.
The tally lamp illuminates.
[INT STBY] changes to [Ü INT REC] while recording frames, and [Ü INT] and a countdown until the next
recording between recordings.
2 Press the START/STOP button again to stop recording.
All of the recorded frames are joined together into one clip.
The tally lamp goes out and [INT STBY] appears at the top of the screen (with [INT] flashing).
3 When you have finished recording, turn off the special recording mode.
Repeat steps 1 and 2 of the previous procedure selecting [Normal Recording] instead.
NOTESNOTES
If Long GOP compression was being used, the bit rate will change automatically to an option with Intra-frame
compression.
You can use only one special recording mode at a time.
The interval and the number of frames recorded cannot be changed while recording.
Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
If the system frequency is changed, interval recording mode will be canceled and the interval recording
settings will be reset to default values.
[3 Recording/Media Setup]
[Recording Mode]
[Normal Recording]
[3 Recording/Media Setup]
[Special Recording Settings]
[Interval Recording]
[Interval] ….. [1 sec]
[Recorded Frames] ….. [1]