Operation Manual

143
Custom Picture Settings
[Area A Setting Y Level], [Area B Setting Y Level]: Adjusts the brightness for area A or B, respectively. This setting
can be adjusted from 0 to 31. (Default: 16)
[Area A Revision Level], [Area B Revision Level]: Adjusts the amount of correction to the color saturation in area A
or B, respectively. This setting can be adjusted from –50 to 50. (Default: ±0)
[Area A Revision Phase], [Area B Revision Phase]: Adjusts the amount of correction to the color phase in area A
or B, respectively. This setting can be adjusted from –18 to 18. (Default: ±0)
[Other Settings] > [Other Functions]
[Setup Level]: Adjusts the black level set by the [Black] > [Master Pedestal] setting. This setting can be
adjusted from –50 to 50. (Default: ±0)
[Over 100%]: This function determines how the camera handles video signals exceeding 100%. Available
options are [Through] to do nothing, [Clip] to clip the signal at 100%, and [Press] to compress a
signal of up to 108% down to 100% levels. (Default: [Through])
NOTES
•If [/ Custom Picture] > [Other Settings] > [Activate] is set to [On], when an optional RC-V100 Remote
Controller is connected to the camera, the following custom picture settings can be changed using the
buttons and dials on the remote controller.
- [Other Settings] > [Black] > [Master Pedestal], [Master Black Red], [Master Black Blue]
- [Other Settings] > [Black Gamma] > [Level]
- [Other Settings] > [Knee] > [Slope], [Point] (only when [Knee] > [Activate] is set to [On])
- [Other Settings] > [Sharpness] > [Level]
- [Other Settings] > [White Balance] > [R Gain], [B Gain]