Operation Manual

151
Playback
Playback Controls
The following playback types are available using either the playback buttons
on the monitor unit (“Buttons” in the table below) or the onscreen joystick
guide and any of the joysticks.
NOTES
There is no audio during any of the playback types listed in the previous table.
During some playback modes, you may notice some anomalies (blocky video artifacts, banding, etc.) in the
playback picture.
The speed indicated on the screen is approximate.
If the clip’s bit rate setting includes Long GOP compression, during frame advance, the time advanced
between frames depends on the video configuration used: 0.2 seconds (when the frame rate is 59.94P), 0.24
seconds (when the frame rate is 50.00P) and approximately 0.5 seconds for other video configurations.
You can press the DISP. button on the monitor unit or an assignable button set to [Display] (A 131) to turn
the joystick guide display on and off.
Adjusting the Volume
You can connect headphones to the × (headphone) terminal to listen to
the audio during playback. Adjust the headphone volume with the
[¡ Audio Setup] > [Audio Output] > [Headphone Volume] setting. If
you set an assignable button to [Headphones +] or [Headphones –]
(A 131), you can press the button to adjust the headphone volume
without using the menu.
The audio signal will also be output from the REC OUT terminal, MON.
terminal and HDMI OUT terminal.
NOTES
For details on changing the audio channel, refer to
Audio Output
(A 169).
Playback type Operation
Fast playback
Buttons: Press the Ø or × button.
Joystick: During playback, push the joystick up or down.
Repeat to increase the playback speed to approximately 5x
15x 60x the normal speed.
Frame advance/reverse Joystick: During playback pause, push the joystick up or down.
Skip to the beginning of
the next clip
Buttons: Press the Ù button.
Joystick: Push the joystick right.
Skip to the beginning of
the current clip
Buttons: Press the Ú button.
Joystick: Push the joystick left.
Skip to the previous clip
Buttons: Press the Ú button twice.
Joystick: Push the joystick left twice.
Return to playback mode
Buttons: Press the Ò button.
Joystick: Press the joystick itself (SET button).
× (headphone)
terminal