Operation Manual

Preparing the Camera

Using the Viewfinder

The camera’s viewfinder features an OLED screen that turns on

automatically when you look through the viewfinder. The screen also turns

off automatically shortly after you stop using the viewfinder.

Adjusting the Viewfinder

1 Gently pull out the viewfinder until it stops and adjust the angle as

necessary.

2 Turn on the camera and adjust the dioptric adjustment lever until the

viewfinder’s image is sharp.

NOTES

• You can turn on the viewfinder permanently by setting [¢ Picture/Terminals Setup] > [Viewfinder Setup] >

[Eye Sensor] to [Off].

Attaching and Removing the Eye Cup

Attach the eye cup so that it covers the rubber rim of the viewfinder unit.

To remove the eye cup, pull it gently in a “peeling off” motion from the

bottom up.

• For left eye use, attach the eye cup so that the protruding part faces the

opposite side.

IMPORTANT

• Pointing the viewfinder lens at the sun or other strong light sources may

cause damage to internal components. When you are not using the

viewfinder, make sure to attach the viewfinder cap to the viewfinder.

This will also protect the viewfinder from scratches and dirt. Attach the

viewfinder cap by inserting it into the rubber rim of the viewfinder unit.

Using the LCD Panel

The whole monitor unit can be rotated 270º sideways allowing for

easy monitoring and operation from the side of the camera.

Additionally, the independently articulated LCD panel can be

rotated 180º sideways and 270º up and down. In combination, you

can position the LCD panel at a comfortable angle whatever the

shooting style you need.

1 Rotate the monitor unit sideways to the desired angle.

2 Open the LCD panel and adjust the screen to the desired

position.

햲

햳

Dioptric

adjustment lever

Eye cup

Viewfinder

unit

햲

햳