Operation Manual

Adjusting the Focus
80
NOTESNOTES
• About Peaking/Magnification:
- You can use the [ Assistance Functions] > [Peaking] > [Peaking 1] and [Peaking 2] settings to set the
color, gain and frequency of the two peaking levels independently of each other.
- You can select individually whether to display the assistance functions on the LCD screen, the viewfinder or
the MON. and HDMI OUT terminals with the display/output settings under [ Assistance Functions] >
[Peaking] and [ Assistance Functions] > [Magnification].
- You can also use the [Focus Assistance B&W] setting under [ Assistance Functions] > [Peaking] or
[Magnification] to switch the screen to black & white while using the respective assistance function.
- The assistance functions will not affect your recordings.
• The Dual Pixel Focus Guide function cannot be used in the following cases:
- While the focus is being adjusted automatically using one-shot AF or continuous AF.
- When the aperture value used is F11 or larger.
- When a manual focus lens is attached to the camera.
• When the Dual Pixel Focus Guide function and Face AF functions are used together, the focus guide may not
focus the main subject’s eyes correctly, depending on the direction in which the face is turned.
One-Shot AF
In this focus mode, you will focus manually in most situations but still have the option to have the camera focus
automatically only once on the subject inside the AF frame that appears on the screen. You can also change the
size and position of the AF frame.
1 Set the focus mode switch on the lens to AF.
• @ will appear on the left of the screen.
2 Open the focus [AF Mode] submenu.
[v Camera Setup] > [Focus] > [AF Mode]
3 Select [One Shot] and then press SET.
4 If necessary, change the size and position of the AF frame
(A 83).
5 Press and hold the ONE-SHOT AF button.
• A white AF frame will appear on the screen and the camera will
focus automatically. When you are using Face AF, the face
detection frame around the face of the person who has been
determined to be the main subject will turn white.
• When correct focus has been achieved, the AF frame turns
green. If the camera cannot focus automatically, the AF frame
will turn red.
• The AF frame will disappear when you release the ONE-SHOT
AF button.
NOTESNOTES
• One-shot AF is not available when the shutter speed mode is set to [Slow] and the shutter speed is set to 1/4
or 1/3.
• One-shot AF is not available when Face AF is set to [Face Only] and a face has not been detected.
• When the aperture value used is F11 or higher, Dual Pixel CMOS AF will not work and the camera will focus
using contrast-detection autofocus.
[v Camera Setup]
[Focus]
[AF Mode]
[One Shot]