Operation Manual

157
Applying a LUT to Video Outputs
Using a User LUT
Once you create a LUT file (.cube format) with Blackmagic Design’s DaVinci Resolve, you can register it in the
camera as a user LUT and then apply it to some video outputs in a similar way to the preset LUTs. When
recording using special gamma curves, you can apply the user LUT to video output from the VIDEO terminal
(optional viewfinder), SDI OUT terminals, MON. terminals or HDMI OUT terminal. Use an SD card to load up to
four LUTs into the camera and register them.
Note that you cannot apply the user LUT to sub recording (XF-AVC Proxy) clips.
Registering a User LUT
1 Insert the SD card containing the LUT file (.cube format) created in Blackmagic Design’s DaVinci Resolve into
the camera’s SD card slot.
2 Open the [Register] submenu.
HOME screen: [COLOR] > [USER LUT] > [Register]
Monitoring menu: [Monitoring Setup] (
¢ ) > [LUT] > [User LUT] > [Register]
3 Turn the SELECT dial to select a slot in the camera (user LUT 1 to 4) to which the LUT file will be saved and
then press SET.
4 Select the desired LUT file on the SD card and then press SET.
5 Select the desired output color space and then press SET.
• Available options are [BT.709 Gamut] and [BT.2020 Gamut]. To leave the color space unconverted, select
[Do Not Convert].
6 Select the desired output range and then press SET.
• Available options are [Narrow Range] and [Full Range].
7 Press both [LOAD] buttons simultaneously (HOME screen) or select [OK] and then press SET (monitoring
menu).
• The selected LUT file will be registered in the camera.
8 Press [OK] (HOME screen) or press SET (monitoring menu).
Applying a User LUT to Video Outputs
1 Open the [LUT] submenu.
HOME screen: [COLOR] > [LUT]
Monitoring menu: [Monitoring Setup] ( ¢ ) > [LUT]
2 Select the desired terminal and then press SET.
3 Select the desired user LUT (user LUT 1 to 4) and then press SET.
• Only registered user LUTs are displayed.
• The user LUTs are displayed with a  icon in front of the name.
Selecting the Output Color Space
If you select an output color space, the color space will be converted when the user LUT is applied.
1 Open the [Color Space(Output)] submenu.
HOME screen: [COLOR] > [USER LUT] > [Color Space(Output)]
Monitoring menu: [Monitoring Setup] ( ¢ ) > [LUT] > [User LUT] > [Color Space(Output)]
2 Turn the SELECT dial to select the desired user LUT (user LUT 1 to 4) and then press SET.
3 Select the desired output color space and then press SET.