User manual

The flash always fires at full output.
Flash units other than EL/EX series Speedlites used in autoflash mode always fire at full
output ( ).
The flash always fires at full output when [Flash metering mode] in external flash
Custom Function settings is set to [1:TTL] (autoflash) ( ).
Flash exposure compensation cannot be set.
If flash exposure compensation is already set with the Speedlite, flash exposure
compensation cannot be set with the camera. When the Speedlite's flash exposure
compensation is canceled (set to 0), flash exposure compensation can be set with the
camera.
High-speed sync is not available in <Fv> or <Av> mode.
Set [Slow synchro] in [ : External Speedlite control] to an option other than [1/200
sec. (fixed)] ( ).
Remote control shooting is not possible.
Check the position of the remote control's release timing switch.
If you are using Wireless Remote Control BR-E1, see Remote Control Shooting or
Connecting to a Wireless Remote Control.
To use a remote control for time-lapse movie recording, see Time-Lapse Movies.
A white [ ] or red [ ] icon is displayed during movie
recording.
Indicates that the camera's internal temperature is high. For details, see Warning
Indicator Display in Movie Recording.
Movie recording stops by itself.
If the card's writing speed is slow, movie recording may stop automatically. For details
on cards that can record movies, see Card performance requirements (movie
recording). To find out the card's writing speed, refer to the card manufacturer's website,
etc.
Perform low-level formatting to initialize the card if the card's writing or reading speed
seems slow ( ).
Movie recording stops automatically at 2 hr.
In High Frame Rate movie recording, recording stops automatically at the following
times.
• Set to 119.88/100.00 fps: 30 min.
• Set to 179.82/150.00 fps: 20 min.
887