User manual

429
11: Connection target not found
 In the case of [q], is Camera Connect running?
B Establish a connection using Camera Connect (=
360).
 In the case of [D], is the EOS software running?
B Start the EOS software and reestablish the connection (=
376).
 In the case of [l], is the power of the printer on?
B Turn on the printer.
 Are the camera and the access point set to use the same password for
authentication?
B This error occurs if the passwords do not match when the
authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct password for authentication is
set on the camera (=
427).
12: Connection target not found
 Is the power of the target device and access point on?
B Turn on the target device and access point, then wait a while. If a
connection still cannot be established, perform the procedures to
establish the connection again.