Wi-Fi Function Instruction Manual
Table Of Contents
- Cover
- Introduction
- Getting Started
- Connecting to a Bluetooth-compatible Smartphone via Wi-Fi
- Connecting to an NFC-compatible Smartphone via Wi-Fi
- Connecting to a Smartphone via Wi-Fi with the Wi-Fi Button
- Connecting to Another Camera via Wi-Fi
- Connecting to Connect Station via Wi-Fi
- Connecting to EOS Utility via Wi-Fi
- Connecting to a Printer via Wi-Fi
- Sending Images to a Web Service
- Advanced Wi-Fi Connection
- Reconnecting via Wi-Fi
- Checking and Operating Connection Settings
- Troubleshooting Guide
- Reference
Connecting to a Detected Network Manually via Wi-Fi
120
Enter the password specified for the access point. For details on the
specified password, refer to the access point’s instruction manual.
The screens displayed in steps 6 to 7 below vary depending on the
authentication and encryption specified for the access point.
Go to step 8 when the [IP address set.] screen is displayed instead
of the screens for steps 6 to 7.
6
Select a key index.
The [Key index] screen is displayed
only if WEP encryption is used by the
access point.
Select the key index number
specified for the access point, then
press <0>.
Select [OK] and press <0> to go to
the next screen.
7
Enter the password.
Enter the password using the virtual
keyboard (p.160), then press the
<M> button.
The [IP address set.] screen (p.121)
will be displayed.
Entering the Access Point Password