Wi-Fi Function Instruction Manual
Table Of Contents
- Cover
- Introduction
- Getting Started
- Connecting to a Bluetooth-compatible Smartphone via Wi-Fi
- Connecting to an NFC-compatible Smartphone via Wi-Fi
- Connecting to a Smartphone via Wi-Fi with the Wi-Fi Button
- Connecting to Another Camera via Wi-Fi
- Connecting to Connect Station via Wi-Fi
- Connecting to EOS Utility via Wi-Fi
- Connecting to a Printer via Wi-Fi
- Sending Images to a Web Service
- Advanced Wi-Fi Connection
- Reconnecting via Wi-Fi
- Checking and Operating Connection Settings
- Troubleshooting Guide
- Reference
74
This section describes how to connect the camera and Connect Station
(sold separately) via Wi-Fi using the NFC function. To save images in
other ways, refer to the Connect Station Instruction Manual.
On the [Wi-Fi settings] screen, set [Wi-Fi] to [Enable] and set [NFC
connection] to [Enable] in advance (p.12, 159).
1
Hold the camera close to Connect
Station.
Turn on the camera and Connect
Station, then hold the camera’s p
mark close to the Connect Station’s
NFC connect point.
When a message indicating the Wi-Fi
connection is being established is
displayed on the camera’s LCD
monitor and Connect Station
responds, move the camera away
from Connect Station.
When a Wi-Fi connection is
established, Connect Station checks
the images on the memory card, then
saves only the unsaved images.
2
Terminate the Wi-Fi connection.
After images are saved, the screen
on the left will appear on the camera’s
LCD monitor. Press <0> to
terminate the Wi-Fi connection.
Saving Images
NFC connect point