Service Manual

Canon NEW F-1 Service manual
Page 14
Assembly and Adjustment Notes
8. Attach the light shield (12) and seal (13) as shown.
9. Pentaprism Contact Installation
9.1. Don't interchange the
position of the left and right
contacts, or reverse either of
them.
9.2. Solder the leads as quickly
as possible. Excessive heat will
loosen the contact pins.
10. Main Flex Installation
10.1. Solder the main flex (16) at the following positions.
10.2. To prevent the main flex from interfering with the top cover screw holes, fix it with
double-sided tape.
10.3. The brown leads to SW12 are interchangeable.
See section 9 (Upper Body)
for the correct bending of
the flex.
Note: Numbers in parentheses in the text correspond to circled numbers
on page 12. Disassemble in normal order and reassemble in reverse order.