Service Manual

Canon NEW F-1 Service manual
Page 54
Assembly and Adjustment Notes
1. Lubricate all lever pivot shafts with
MIL-G.
2. Lubricate the friction surfaces (/////
marks) with Lozoid 72090. Lubricate
the
slots of the brake lever [p/o the
mirror charge lever (4)-4] with MIL-
G.
3. Check the positions of all the springs
(see above).
4. Following needle lever
4.1 Slip the end of the following needle
lever (7) under the resistor section
of AE unit.
4.2 The bottom end of lever (7) should
be engaged with the lowest part of
lever A and shown below.
4.3 The aperture signal lever should
work smoothly with no trace of
roughness.
4.4 Lever (7) must also work smoothly
when the stop-down slide is
activated.
4.5 When the max. aperture correction
pin is moved the correction lever
(9) must work smoothly.
Note: Numbers in parentheses in the text correspond to circled numbers on page 53.
Disassemble in normal order and reassemble in reverse order.