Service Manual

Canon NEW F-1 Service manual
Page 62
Assembly and Adjustment Notes
1. The thinner side of the eyepiece mask (6) goes to the right.
2. Eyepiece Frame (7)
2.1 The plastic foam light shield in eyepiece frame (7) should not be visible.
2.2 The notch in the frame goes down.
3. Full the space between the accessory cover (1) and the diecast pentaprism box with
black diabond.
4. Apply oil retardant OBF-10 around the junction of the die casting and eyepiece lens.
(Water resistance)
5. Use the special tool to install the Button ring (10),
6. Pentaprism Cover Installation
6.1 Install the cover from the front first.
6.2 When covering rear (eyepiece) side keep the cover level as it is lowered into place.
Note: Numbers in parentheses in the text correspond to circled nurnbers on page 61.
Disassemble in normal order and reassemble in reverse order.