Operation Manual
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
4
MAKING COPIES
4-1
4
MAKING COPIES
Copying documents
One of the convenient features of the fax is its ability to make high quality copies. You can make
up to 99 copies of one document at a time.
If you make copies of multiple documents at a time, the number of pages the fax can scan into
memory varies depending on the scanning resolutions (see p. 5-1) as follows:
• STANDARD/FINE = 15 pages
• PHOTO = 3 pages
• STANDARD and FINE result in the same resolution when making copies.
• If MEMORY FULL appears on the LCD when making multiple copies, see Copying
problems, p. 9-16.
1
Load the document face up into the document tray.
See Loading documents, p. 3-2.
2
Press [Resolution].
You can select STANDARD, FINE or PHOTO.
Press [Start/Copy].
3
Enter the number of copies (up to 99) using the numeric buttons.
To make a correction to the number of copies, press [Clear] and re-enter the number.
Press [Start/Copy].
To stop copying anytime, press [Stop]. If the document does not eject, press [Start/Copy] for a few
seconds, then the fax will feed out the document. See Jams in the document tray, p. 9-1.
COPY PAGE 01