Operation Manual
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
8-6
TAM SETTINGS (FAX-B840 only)
CALLER ID
Name Description Settings
MESSAGE LENGTH Set the maximum recording time for each recorded message. 0 seconds/30
seconds/60 seconds/
120 seconds
PAS SWO RD Set a four-digit PIN so that you can access the fax from
remote locations.
0000 to 9999
TOLL SAVER Setting this feature to ON allows calls to be picked up after 2
rings when you have a new message.
ON/OFF
RING COUNT If you set TOLL SAVER to OFF, this feature allows you to set
the number of times the fax rings.
1 to 15 times
FWD SETTINGS Allows you to forward messages. ON/OFF
FWD TEL NUMBER Forwarding telephone number.
A maximum of 40 digits can be entered.
–
AUTO REDIAL Redial the previously dialed number.
REDIAL TIMES: Set the number of retries.
REDIAL INTERVAL: Set the period of time between redialing
attempts.
ON/OFF
1 to 2 times
1 to 99 minutes
PIN ENTRY PIN confirmation. ON/OFF
TAM MONITOR Allows you to screen all incoming calls. ON/OFF
Name Description Settings
CALLER ID Determine if the fax displays the caller's name and phone/fax
number when receiving a call.
ON/OFF
ANONYMOUS* Allows you to reject anonymous calls.
REJECTION METHOD: Set the way the fax rejects calls.
ON/OFF
DISCONNECT/
PLAY MESSAGE
SELECTIVE* Allows you to reject calls from specific numbers.
NUMBER TO REJECT (00-09) : Set the phone/fax numbers to
be rejected. A maximum of 20 digits can be entered.
REJECTION METHOD: Set the way the fax rejects calls.
ON/OFF
_
DISCONNECT/
PLAY MESSAGE
OUT OF AREA* Allows you to reject out-of-area calls.
REJECTION METHOD: Set the way the fax rejects calls.
ON/OFF
DISCONNECT/
PLAY MESSAGE
SHOW IN HISTORY?* Determine if the fax stores the phone/fax numbers for rejected
calls.
YES/NO
* FAX-B840 only.