Operation Manual
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
2-5
PREPARING TO USE YOUR FAX
2
■ Entering symbols
Correcting mistakes ___________________________
You can clear an entire entry by pressing [Clear]. Alternatively, follow the procedure below to
correct individual letters:
3
Continue entering other letters or numbers using the numeric buttons.
• If the next letter you want to enter is under a different numeric button, simply press that button until
the letter you want appears.
-or-
If the next letter you want to enter is under the same numeric button you pressed in step 2, press [ ]
to move the cursor to the right. Then press that same numeric button repeatedly until the letter you
want appears.
• To enter a space, press [Space].
1
Press [#] repeatedly until the symbol you want appears.
2
If you want to enter another symbol, press [ ] to move the cursor to the right, then press
[#] repeatedly until the symbol you want appears.
1
Use [ ] or [ ] to move the cursor under the incorrect letter.
2
Use the numeric buttons to enter the correct letter over the incorrect letter.
3
When you have finished making corrections, press [Start/Copy] to register your new entry.
# :1
CANEN:A
CANON:A