Operation Manual
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
7-8
Playing telephone messages
Telephone messages will be played back in order from the oldest message recorded. If a voice
memo has been recorded, it will be played back first.
Follow the procedures below to delete all messages.
1
Press [Play].
The day and time when the telephone message was recorded, the number of telephone messages and the
number of the message being played (ICM No.) are displayed whenever a message is played.
1
Press [Delete].
2
Press [ ] to delete all messages.
• A voice memo is not deleted (see p.7-6).
• If you change your mind and decide not to delete all messages, press [#].
SUN 17:15 02/05
• Press [ ] to listen to the message again. (Repeat)
• Press [ ] to play the next message. (Skip)
• Press [ ] twice to play the previous message.
• Press [Stop] to stop playback.
• Press [Delete] during playback to delete a message.
• Use [ ] or [ ] to change the volume.
YES=( ) NO=(#)