Operation Manual
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
7-11
USING TAM MODE (FAX-B840 only)
7
■ List of remote control commands
* Sub-commands are only valid while the command they are linked to is active.
** When no forwarding number has been set, ICM forwarding mode cannot be set. When TAM MODE has
not been set, entering this command activates TAM MODE and ICM forwarding mode simultaneously.
Command
11#
19#
20#
21#
29#
31#
32#
33#
34#
41#
42#
43#
44#
50#
51#
60#
61#
89#
99#
Sub-command*
4#
6#
5#
9#
#
4#
5#
#
#
#
#
4#
5#
4#
5#
4#
5#
4#
5#
Description
Play ICM
Repeat
Skip
Stop playback
Delete
Delete all ICM
Record voice memo
End recording
Play voice memo
Repeat
Stop playback
Delete voice memo
Record outgoing message
End recording
Record alternative outgoing message
End recording
Record forwarding message
End recording
Record FAX/TEL switching message
End recording
Play outgoing message
Repeat
Stop playback
Play alternative outgoing message
Repeat
Stop playback
Play forwarding message
Repeat
Stop playback
Play FAX/TEL switching message
Repeat
Stop playback
Cancel TAM MODE
Set TAM MODE
Cancel ICM forwarding mode
Set ICM forwarding mode**
Delete voice memo/all ICM messages
End remote control