Operation Manual

34 Receiving Faxes
6 Use [{] or [}] to select <ON> (YES), then press [Start/Copy].
z If you set to <OFF>, the setting goes on to the next <CALL REJECTION> setting.
z If you set <SHOW IN HISTORY?> to <YES> or <NO>, the setting returns to <TEL
REGISTRATION>.
7 z If you set <ANONYMOUS> or <OUT OF AREA> to <ON>, press [Start/Copy]
twice. Proceed to step 12.
z If you set <SELECTIVE> to <ON>, register the specific phone/fax numbers you
want to reject in <REJECTED NUMBER> list. Follow the steps below.
8 Press [Start/Copy].
9 Use [{] or [}] to select the number of <REJECTED NUMBER> list (00-09) under
which you want to register the phone/fax number, then press [Start/Copy].
10 Enter the phone/fax number using the numeric buttons, then press [Start/Copy].
11 To assign additional numbers, repeat the procedure from step 8.
To finish, press [Menu], then press [Start/Copy].
12 Use [{] or [}] to select <PLAY MESSAGE> or <DISCONNECT>, then press
[Start/Copy].
z <PLAY MESSAGE>: The call will be disconnected after the <ALT OUTGOING MSG> (see
page 37) is played. If you set <SELECTIVE> to <ON> in step 5, and want to select this
setting, <OUTGOING MESSAGE> must have been recorded.
z <DISCONNECT>: The call will be disconnected without notice.
13 Press [Stop] to return to standby mode.