Operation Manual

45Using TAM Mode (FAX-JX500/JX300 only)
Forwarding Telephone Messages
This feature allows you to automatically forward telephone messages, recorded when the fax is set
to <TAM MODE>, to a registered forwarding number.
You can use remote control to access the forwarding number and listen to your telephone
messages.
 Setting the Forwarding Number
1 Press [Menu].
2 Use [{] or [}] to select <DATA REGSTRATION>, then press [Start/Copy]. The
LCD displays <USER SETTINGS>.
3 Use [{] or [}] to select <TAM SETTINGS>, then press [Start/Copy]. The LCD
displays <MESSAGE LENGTH>.
4 Use [{] or [}] to select <FWD SETTINGS>, then press [Start/Copy]. The LCD
displays <OFF>.
5 Use [{] or [}] to select <ON>, then press [Start/Copy] twice. The LCD displays
<TEL=>.
6 Use the numeric buttons to enter the forwarding number, then press [Start/Copy].
A maximum of 40 digits can be entered.
7 Press [Stop].
Setting ends and the fax returns to standby mode.
 Setting the Number of Redial Times
1 Follow steps 1 to 4 on page 45.
2 Use [{] or [}] to select <ON>, then press [Start/Copy]. The LCD displays <FWD
TEL NUMBER>.
3 Use [{] or [}] to select <AUTO REDIAL>, then press [Start/Copy]. The LCD
displays <ON>.
4 Use [{] or [}] to select <ON>, then press [Start/Copy] twice. The LCD displays
<2TIMES>.
5 Use the numeric buttons, or [{] or [}] to enter the number of redial times, then
press [Start/Copy] twice. The LCD displays <2MIN.>.
Note
z You must register a forwarding number and set <TAM MODE> before you can use this feature. Remote
control cannot be used to set this feature unless a forwarding number has been registered.
z If you set <FWD SETTINGS> to <ON> when a forwarding message has not been recorded, you will
hear a tone instead of a forwarding message when telephone messages are forwarded.