Operation Manual

4-45
FAX-L1000 Chapter 4: Maintenance and Service
5.2.2 Error codes
a) Service error code output
If Service Data #1 SSSW SW01 bit 0 is set to “1”, then service error codes are printed on
the activity management reports, reception result reports, error transmission reports, and
system dump lists when communication ends in an error. Also, the following is displayed
on the display when an error occurs.
REFERENCE
For samples of reports with the service error codes displayed, see Chapter 2:
2.1.2 Service report output functions .
Figure 4-45 Service Error Code Display
b) Measure when an error code is output
Section c) shows the error codes displayed on this fax. However, they do not include the
causes and measures that are described in a separate document titled
G3 Facsimile Error
Code List (Rev. 1)
. See also this document.
The measures shown in the
G3 Facsimile Error Code List (Rev. 1) and applicable to this
fax machine are explained below.
•Increase the transmission level
Set service data #2MENU Parameter No.07 to -8 (dBm).
•Decrease the transmission level
Set service data #2MENU Parameter No.07 to -15 (dBm).
03/03/2000 WED 19:00
Display repeated
CHECK PRINTER
##0325