Operation Manual

4-57
FAX-L1000 Chapter 4: Maintenance and Service
#0059 [TX] The number you dial and connected number (CSI) does not
match
Cause: “USER TEL” on the reception side not programmed, or wrongly
programmed.
Solution: (1) Contact reception side and check whether “USER TEL” has been
properly programmed.
(2) Check that the designated other party is connected, and transmit
manually.
Cause: Faulty operation by exchange. Designated other party is not connected.
Solution: Inspect exchange.
#0080 [TX] Other party does not have ITU-T recommended subaddress
reception
Cause: The other party’s DIS bit 49 is 0.
Solution: Contact the other party and confirm whether or not their fax supports
subaddress receiving. Try sending again without a subaddress.
#0081 [TX] Other party does not have ITU-T recommended password
reception
Cause: The other party’s DIS bit 50 is 0.
Solution: Contact the other party and confirm whether or not their fax supports ITU-
T password receiving. Try sending again without a password.
#0082 [RX] Other party does not have ITU-T recommended selective
polling transmission function
Cause: The other party’s DIS bit 47 is 0.
Solution: Contact the other party and confirm whether or not their fax can accept a
polling request with a subaddress. Try again without a subaddress.
#0083 [RX] DCN received during polling reception
Cause: Subaddress/password does not match.
Solution: Contact the other party and conform that the subaddress/password that you are
using are correct.
#0084 [RX] In polling reception, other party does not have ITU-T
recommended password reception
Cause: The other party’s DIS bit 50 is 0.
Solution: Contact the other party and confirm whether or not their fax supports
receiving a polling request with an ITU-T password. Try again without a
password.