Operation Manual

5-55

FAX-L1000 Chapter 5: Appendix

b-4) Check after DRAM boards installation

After installing the DRAM boards, carry out the following procedure to ensure that the

DRAM boards are properly identified by the fax.

(1) Referring to the flow chart, enter test mode D-RAM test [1].

Figure 5-11 Flowchart of D-RAM test 1

(2) When D-RAM test [1] is entered, check the D-RAM write-in and read-out. Confirm

that the display shows the extended memory capacity value, and that the check

completes with “no error”.

Figure 5-12 D-RAM Board Installation Check

(3) After confirming this, push the Stop button, then push the Clear button, which will

put the machine into a standby condition.

(4) If the process does not complete normally, return to

b-3) Attaching memory

boards

, re-attach the memory board, and then re-check with the D-RAM test.

Data Registration

Set

SERVICE MODE

TEST MODE

SERVICE MODE

#1 SSSW

TEST MODE [1]-[9],[#]

CFYA: (ROM Ver)

1: D-RAM 11648K

[1] --- [2]

1: D-RAM 11648K

✱✱✱✱

Display TEST MODE by

pressing or button

1:D-RAM 11648K

complete (no error)

Indicates memory capacity

(4MB option memory: 7552 Kbytes)

(8MB option memory: 11648 Kb

ytes)