Operation Manual

5-172
FAX-L1000 Chapter 5: Appendix
##1002 [TX/RX] No route to specified transit network.
Cause: Indicated above
Solutions: (1) Re-check the method of connection to the designated relay
network.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in D-channel connection
error
in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.
##1003 [TX/RX] a) No route to destination.
b) Designated bearer service not implemented.
Cause a): Indicated above
Solutions a): (1) Re-check the phone number and try the call again.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in
D-channel connection
error
in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.
Cause b): Indicated above
Solutions b): (1) Re-check the designated bearer service.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in
D-channel connection
error
in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.
##1006 [TX/RX] Channel unacceptable.
Cause: Indicated above
Solutions: (1) Wait a while and then transmit, because the other terminal is in
the middle of a transmission.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in
D-channel connection
error in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.