Operation Manual

5-189
FAX-L1000 Chapter 5: Appendix
##1099 [TX/RX] Information element non-existent or not implemented
Cause: Indicated above
Solutions: (1) Re-establish communication.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in
D-channel connection
error in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.
##1100 [TX/RX] Invalid information element contents
Cause: Indicated above
Solutions: (1) Re-establish communication.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in
D-channel connection
error
in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.
##1101 [TX/RX] Message not compatible with call state
Cause: Indicated above
Solutions: (1) Re-establish communication.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in
D-channel connection
error in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.
##1102 [TX/RX] Recovery on timer expire
Cause: Indicated above
Solutions: (1) Re-check the designated relay network, and re-establish
communication.
(2) Output a communications analysis list, and analyze it.
(3) Make sure the 4 digits of the applicable error code are registered in
#4C ISDN BASIC, [G4/G3 Fallback] and [Speech Fallback] .
(4) Take countermeasures as outlined in D-channel connection
error
in this Chapter, 3.6.6 Maintenance and service, c)
Communication problems.
(5) Make an inquiry to the maker of the Switching equipment.