Service manual
4-11
LASER CLASS 1060P Chapter 4: Maintenance & Service
“NO RX PAPER” (#012)
Cause: The receiving fax machine declares no paper in DIS, or its memory is full.
Solution: Contact the other party, and ask them to put paper in their machine, or to clear their
fax machine’s memory.
“NO TEL #” (#022)
Cause: The button you pressed has no number registered for One-Touch Speed Dialing,
Coded Speed Dialing, or Group Dialing.
Solution: Print a list of registered numbers and make any corrections needed, then try again.
“NOT AVAILABLE”
Cause: One-touch or coded speed dial already registered.
Solution: Check the contents of the one-touch or coded speed dialling registration, then try
again.
“PSWD ROLL REJECT” (#084)
Cause: You set up a polling box for polling sending with an ITU-T password, but the other
party’s fax unit does not support use of an ITU-T password for polling receiving.
Solution: Transmit without an ITU-T password.
“PSWD TX REJECTED” (#081)
Cause: You attempted to send a document with an ITU-T password, but the other party’s fax
unit does not support use of an ITU-T password for receiving.
“SELECT POL REJCT (#082)
Cause: You have setup a polling box for polling sending with an ITU-T subaddress, but the
other party’s fax unit does not support use of an ITU-T subaddress for polling receiv-
ing.
Solution: Transmit without a subaddress.
“START AGAIN”
Cause: An error occurred on the phone line or in the system.
Solution: Start the procedure again from the beginning.
“SUBADD TX REJECT” (#080)
Cause: You attempted to send a document with an ITU-T subaddress, but the other party’s fax
unit does not support receiving a document with an ITU-T subaddress.
Solution: Transmit without a subaddress.