Service manual

4-18
LASER CLASS 1060P Chapter 4: Maintenance & Service
#003 [TX/RX] Copy page transmission time over
Cause: One page of the document was longer than 39.4 inches (1 meter) or transmission/
copying took longer than the regulated time (32 minutes).
Solutions: (1) Use a copy machine to copy the document onto serveral shorter page, then
tranmit/copy.
(2) Raise the page timer value with Service Data #1 SSSW SW12.
Cause: Reception took longer than the regulated time (32 minutes).
Solutions: (1) Have the other party split the document over multiple pages and receive it that
way.
(2) Contact the other party and check the cause.
(3) Raise the page timer value with Service Data #1 SSSW SW12.
Cause: Internal structure defect.
Solutions: (1) Check if the document sensor (DS) and document edge sensor (DES) are
operating correctly using the methods given in this chapter,5.1.6 Faculty tests,
Test mode [6] Faculty test, [3] Sensor tests.
(2) Check the document sensor (DS) and OPCNT board (J3) connections.
(3) Check the document edge sensor (DES) and OPCNT board (J4) connections.
(4) Check the SCNT board (J3) and OPCNT board (J2) connections.
(5) Make a copy,and make sure that the document read motor is operating corrctly.
(6) Check the document read motor and PCNT board (J402) connections.
(7) Check the SCNT board (J4) and PCNT board connections.
(8) Replace the document sensor (DS).
(9) Replace the document edge sensor (DES).
(10) Replace the OPCNT board.
(11) Replace the document read motor.
(12) Replace the SCNT board.
(13) Replace the PCNT board.