Setup Instructions for FAXPHONE L75

ManualsBrandsCanon ManualsFax MachineFAXPHONE L75

Set-Up Sheet

Thank you for purchasing the Canon FAXPHONE L75.

To get your machine ready for use, please follow the instructions in this Set-Up Sheet before referring to any

Summary of content (8 pages)

PAGE 1
Set-Up Sheet Thank you for purchasing the Canon FAXPHONE L75. To get your machine ready for use, please follow the instructions in this Set-Up Sheet before referring to any other documentation. Unpack the machine and its components.
PAGE 2
Remove the shipping materials from the machine. 1 Place the machine on a flat surface. 2 Remove all shipping tapes from the exterior of the machine. 3 Gently open the operation panel 1 (it only opens partially) and remove the protective sheet 2 from the ADF. 4 Close the operation panel by pressing the center down until it locks into place. NOTE 1 • Do not remove the USB label A at this stage. 2 A USB label A Assemble the machine. 3 Insert the multi-purpose tray into the slots on the machine.
PAGE 3
Load paper. 1 Insert a stack of paper into the multi-purpose tray 1 (print side facing you and top edge first), then adjust the paper guides A to the width of the paper 2. 2 Attach the multi-purpose tray cover to prevent dust accumulating inside the machine. 1 A 2 2 Attach the handset to the machine. 1 Remove the screws A from the plugs B and insert the plugs into the holes on the handset cradle. B A B 2 Turn the machine so that the left side is facing you and the right side is against a wall.
PAGE 4
Connect the handset and telephone line cord. Handset Place the handset in the cradle. Connect the cord to the h jack. Connect external devices as follows: = Telephone line jack = External device jack = Handset jack • Telephone or answering machine Telephone or answering machine Telephone line External device Connect the cord of an extension telephone, answering machine or data modem to the t jack.
PAGE 5
Install the FX3 cartridge. 1 Lift the latch and open the front cover. 2 Remove the cartridge from its protective bag. 3 Gently rock the cartridge from side to side a few times to distribute the toner evenly inside it. • Print quality may be poor if the toner is unequally distributed. NOTE • Do not open the drum protective shutter on the cartridge. 4 Place and hold the cartridge on a flat, clean surface, then gently pull on the plastic tab to remove the plastic seal.
PAGE 6
Set the fax receive mode. Alarm Receive Mode Pause Hook Image Quality Set Coded Dial Redial Start/Copy Stop Press Receive Mode until the mode you want appears: ex. Fax/Tel Mode You can select from the following: Fax/Tel Mode: When the handset or the extension telephone is connected to the machine, the machine automatically switches between faxes and voice calls.
PAGE 7
Install the Printer Driver. (Windows 98/Me/2000/XP) IMPORTANT • DO NOT connect the USB cable before installing the software. NOTE • When installing the software in Windows XP or Windows 2000, log onto the system as a member of the Administrator group. • If the Found New Hardware Wizard appears, click Cancel, and follow this procedure. 1 Insert the CD-ROM into your CD-ROM drive. 2 If AutoRun is enabled, the installation starts automatically. NOTE • If installation does not start automatically, choose Run.
PAGE 8
5 When prompted, remove the label A from the USB port B. Then connect the USB cable C to the machine and your computer. USB label A C B 6 When the system displays messages indicating that the driver for your printer is being installed, proceed as follows: For Windows 98/Me: Wait for the system to complete the installation of the printer driver. For Windows 2000: When the Found New Hardware Wizard appears during the setup, choose the following: • Search for a suitable driver for the printer.