U.M. 2

fj Stop Priority Method
1
Set the pre- set aperture ring at the desired
f/ stop_
2
Face the camera towards the subject , look
into the viewfinder , and press the meter
circuit switch_
3
While pressing or locking the switch, turn
the shutter speed dial.
4 Set the meter needle at the " 0 " index
within the viewfinder for correct exposure_
• Since
the shutter speed dial cannot be set
at the intermediate positions , the shutter speed
priority method is recommended when exposure
accuracy is a
crucial factor _
•
Light measurement at " B " and "X" of the
shutter speed dial is not possible with the
built -in exposure meter because" B" is used
for long exposures over one second, and "X"
is for the electronic flash unit_
•
When the built-in exposure meter is outside
the coupling range, the meter needle will point
to the top of the viewfinder and will indicate
that proper exposure cannot be obtained_ Refer
to "Coupling Range of B uilt-In Exposure Meter"
on the following page_
19