Operation Manual
019A-07E
This section describes the procedure for performing calibration automatically.
NOTE
If calibration is not automatically performed
When the time between turning the printer OFF once and ON again is less than 8 hours, calibration is not performed.
However, calibration may be performed even if the time is less than 8 hours depending on your environment.
1
Click [ ] displayed in the task tray, and then select a printer name.
2
3
Specify the auto calibration settings.
When performing calibration automatically at the designated time everyday
(1) Select the [Use Periodical Calibration Timer] check box.
(2) Specify the time to perform calibration in [Time].
If calibration is not automatically performed
When the printer is under the following circumstances, calibration is not performed even if [Use Periodical Calibration
Timer] is specified.
When the printer is printing, or an error has occurred (Calibration is performed after the job is completed or the
error is resolved.)
When the time specified in [Time] has come within 30 minutes after performing calibration last time
Auto Calibration Settings
㻤㻢㻌㻛㻌㻟㻠㻟