Operation Manual

4
Press <Apply>.
NOTE:
IP addresses assigned via DHCP/BOOTP/RARP override the address obtained via Auto IP.
Manually entering an IP address
1
Check that <Auto Acquire> is set to <Off>.
If <On> is displayed, select <Auto Acquire> , and set both <Select Protocol> and <Auto IP> to <Off>.
2
Select <Manually Acquire>, and press .
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
Specify the settings in the following order: <IP Address>
<Subnet Mask> <Gateway Address>.
Enter the setting using the numeric keys, and press <Apply> on each screen.
Restart the machine.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
NOTE
Checking whether the settings are correct
Make sure that the Remote UI screen can be displayed with your computer. ( Starting Remote UI) If a computer is not
available, you can check the connection by using the operation panel (
Testing the Network Connection).
Press .
Use / to select <Network Settings>, and press .
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the
Machine
<TCP/IP Settings> <IPv4 Settings> <PING Command>.
Enter the IPv4 address of another device on the network, and press <Apply>.
If a proper connection has been established, the result is displayed as shown above.
Testing the Network Connection
5
1
2
3
4
㻟㻠㻜㻌㻛㻌㻢㻣㻢