Operation Manual

Table Of Contents

0ALJ-08S

Configuring Ethernet Settings

Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication

mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX). In general, the machine can

be used without changing the defaults (

Ethernet Driver Settings), but you can change these settings to

suit your network environment.

Press .

Use / to select <Network Settings>, and press .

If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the

Machine

Select <Ethernet Driver Settings> <Auto Detect>.

Select whether to configure Ethernet settings automatically or manually.

Configuring Ethernet settings automatically

Select <On>, and press . The machine detects and automatically sets the communication mode and the Ethernet type that can

be used.

Configuring Ethernet settings manually

Select <Off>, and press .

Select the communication mode.

Select <Communication Mode>

select <Half Duplex> or <Full Duplex> .

Alternately sends and receives communication data. Select when the machine is connected to a networking device using

half duplex.

Simultaneously sends and receives communication data. Use this setting for most environments.

Select the Ethernet type.

Select <Ethernet Type>

select <10BASE-T> or <100BASE-TX> .

Press <Apply>.

Restart the machine.

Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.

㻟㻣㻝㻌㻛㻌㻢㻣㻢