Operation Manual

1. Check the following.
The computer and machine are connected via the network.
The machine is turned on.
The IP address is set correctly.
The computer and machine are on the same subnet.
Security software has been exited.
2. Click [Update Device List].
If any machines are not displayed by performing the above procedure, perform the following procedure.
1. Click [Search by IP Address].
2. Enter the IP address of the machine to be installed.
"Confirming IP Address Settings"
If the IP address of the machine is between "169.254.1.0 and 169.254.254.255", the IP address is the one
assigned by the AutoIP function.
If an IP address other than link-local addresses is set for the computer, set an IP address in the same subnet
as the computer (other than link-local addresses) also for this machine manually.
This enables the installer to search for this machine.
e-Manual -> "Setting IPv4 Address"
3. Click [OK].
8
Select the function you want to use.
(1) Select the function you want to use (driver to be installed).
(2) Click [Next].
[Printer] Select when using the print function.
[Fax (for Supported
Models)]
Select when using the PC fax function. (This function sends documents or images that were created
on a computer directly as a fax transmission.)
[Scanner] Select when using the scan function.
If another Select Driver screen is displayed, repeat this step until the Confirm Settings screen is displayed.
㻞㻝㻌㻛㻌㻣㻠