i470D Direct Printing Guide

Troubleshooting
39
 An Error Icon is Displayed on the Operation Panel.
302
302302
302
Paper jammed.
Remove the jammed paper, load paper, and press the Resume
ResumeResume
Resume button.
402
402402
402
No print head is installed.
Install the print head following the instructions given in the Easy Setup
Instructions.
403
403403
403
The print head is faulty.
Turn off the printer by pressing the Power
PowerPower
Power button, then turn on the
printer again.
If the same error persists, the print head may be faulty. Contact the
Customer Care Center.
611
611611
611
A specified period of time has lapsed without
receiving a response from the digital camera.
Press the Resume
ResumeResume
Resume button.
The digital camera will automatically turn on. If not, turn it on.
612
612612
612
This printer is not ready for the connected
digital camera or digital video camcorder.
Disconnect the camera connection cable, press the Resume
ResumeResume
Resume button, and
then connect the cable once more.
If the error is still unresolved, there is a possibility that you are using a
digital camera or digital video camcorder that is not supported by this
printer.
Connect a Canon “Bubble Jet Direct” compatible digital cameras or
digital video camcorders.
802/804/806/807/808/809
802/804/806/807/808/809802/804/806/807/808/809
802/804/806/807/808/809
An error requiring a service may have occurred.
Turn off the printer, remove the power cord plug from the outlet, plug the
power cord back in, and then turn on the printer again.
If the same error persists, contact the Customer Care Center.
Note
If the Same Error Persists
If the same error persists after a countermeasure is taken according to the
above error number, turn off the printer, remove the power cord plug from the
outlet, plug the power cord back in, and then turn on the printer again.
Error Icon/Problem Try This
stays lit.
The memory card is inserted
incorrectly.
Insert an available memory card after checking its orientation. See “Using a
Memory Card” on page 8.
If a memory card has already been inserted, remove it and then insert it again.
Next, check that the Indicator lamp stays on.
is flashing.
The memory card cannot be read.
Image data edited/processed on the computer must also be printed from the
computer.
The ?
??
? mark is displayed beside the ink
tank icon.
An ink counter has not been reset after
replacement of the relevant ink tank.
After replacing an ink tank with a new one, reset the relevant ink counter. See
“Replacing an Ink Tank” on page 34.
Error Number/Problem Try This
Note
Never remove the card while image data is being read (the
Indicator lamp is flashing).