i470D Direct Printing Guide

Troubleshooting
41
Cannot Print Properly from the Digital Camera
The following messages may be displayed on the digital cameras or digital video
camcorders when images are printed directly from them. Take the appropriate action to
correct the error.
Notes
z Images can be printed directly from Canon “Bubble Jet Direct” compatible
digital cameras and digital video camcorders connected to this printer.
z If the connected digital camera or digital video camcorder does not support
“Bubble Jet Direct” the Power
PowerPower
Power lamp on the printer will flash eleven times. If
this happens, disconnect the connection cable and press the Resume
ResumeResume
Resume
button.
z If the operation time or data transmission time is too long when the digital
camera or digital video camcorder is connected to this printer, a
communication time error may occur and no more images can be printed. If
this error occurs, press the Resume
ResumeResume
Resume button.
The digital camera will automatically turn on. If not, turn it on.
z A low ink warning is not displayed on the digital camera.
z After replacing an ink tank, cancel the connection with the digital camera
and reset the ink counter. See “Reset the ink counter.” on page 36.
If the ink counter is not reset, the remaining ink level may not be displayed
properly.
z For more details, also refer to the user’s manual for the digital camera or
digital video camcorder.
Error message on camera Try This
Printer in use Images are printed from the computer.
Wait until printing ends.
Printer warming up Wait until warm-up ends.
No Paper Load the paper in the printer and press the Resume
Resume Resume
Resume button on the printer.
Paper Jam Remove the jammed paper, load new media, and press the Resume
ResumeResume
Resume button.
Printer cover open Close the front cover.
No print head No print head is installed. (The Power
PowerPower
Power lamp on the printer flashes six times.)
Install a print head according to the Easy Setup Instructions.
The print head is defective. (The Power
PowerPower
Power lamp on the printer flashes seven times.)
Contact the Customer Care Center.
Waste tank full The waste ink tank is nearly full.
Press the Resume
ResumeResume
Resume button on the printer to recover from the error. Contact the
Customer Care Center as soon as possible.
Paper lever error Incorrect position of the paper thickness lever.
Open the front cover and adjust the paper thickness lever to the left position.
Printer error An error requiring servicing has occurred. (The Power
Power Power
Power lamp on the printer flashes
alternately orange and green.)
Turn off the printer, unplug the power cord from the power supply, plug the
power cord back in, and then turn on the printer. If the same error occurs, contact
the Customer Care Center.