i475D Easy Setup Instructions

FPO
i475D Series
Desktop Photo Printer
Start Here
Easy Setup Instructions
Carefully remove all items from the box.
i475D Series
Desktop Photo Printer
Documentation
and Software Kit
Power Cord
i475D Series Print Head
NOTE: The printer will perform a print
head cleaning after the cover is closed.
Paper Rest
Ink Tanks
BCI-24 Black BCI-24 Color
Open the output tray, then open the front
cover. The print head holder automatically
moves to the center.
Press the Power button. The printer will
initialize.
Plug the power cord into the back of the
printer and connect the other end to a
power outlet.
Remove all shipping tape from the front
and back of the printer.
Write down the serial number located to
the right of the print head holder. You
will need this later to register the product.
Power
Lamp
Power
Button
Shipping
Tape
Serial Number
Output Tray
Front Cover
Output
Tray
Paper Rest
Remove the black ink tank (BCI-24 Black)
from its package and pull off the orange
protective cap.
Insert the black ink tank into the slot on
the right, then push in until the ink tank
clicks into place.
Repeat the procedure for the color ink
tank (BCI-24 Color), inserting it into the
remaining slot.
Close the front cover, attach the paper rest
and pull out the output tray.
Protective Cap
Click
NOTE: Avoid ink at the bottom of the tank.
IMPORTANT: F or correct printer
operation, make sure ink tanks
are secure in slots.
Continue with Step 6
on side two.
Paper
Guide
USB Cable
USB Port
IMPORTANT: Be sure printer is
off before continuing, or the
computer will attempt to install
the printer driver before the
printer is ready.
Connect one end of a USB cable to the
computer, the other to the printer.
Pinch the paper guide and slide it to
the left. Load a sheet of blank paper
in the paper rest. Slide the guide
toward the left edge of the paper.
Turn the printer off.
Click
Remove the print head from its package.
NOTE: Do not touch the electrical
contacts or the print head nozzles.
Raise the gray lock lever on the printer.
Slide the print head into the holder until
it is securely seated.
Do not press it down.
Lower the lever until it clicks into place.
Remove the orange protective cap.
Electrical
Contacts
Tear at notch to open
Print Head
Nozzles
1
2
3
4
5
1
5
4
3
1
2
1
2
3
4
1
2
3
2
Prepare the Printer
1
Unpack the Printer
3
Install the Print Head
4
Install the Ink Tanks
5
Connect the Printer
and Load Paper