i860 Quick Start Guide

Printing Maintenance
60
(5) When the confirmation message is displayed, click OK
OKOK
OK. Print head deep
cleaning starts when the POWER
POWERPOWER
POWER lamp starts blinking. Do not perform any other
operation until the print head deep cleaning is completed. This takes about one
minute.
Important The process takes one or two minutes to complete, so simply
wait until the POWER
POWERPOWER
POWER lamp stops flashing.
Note
After print head deep cleaning finishes, print the nozzle check pattern
to verify that the print head nozzles are clean.
See "Printing the Nozzle Check Pattern
Printing the Nozzle Check PatternPrinting the Nozzle Check Pattern
Printing the Nozzle Check Pattern" on page 51.
If not, check that there are sufficient ink levels in all ink tanks before
turning off printer. Be sure to perform another print head deep cleaning
24 hours after turning off printer.
If this does not resolve the problem, the print head may be worn out.
Contact the Customer Care Center.