User Guide

Protocol Settings

3-8

Using a NetWare Network (Windows)

Protocol Settings

You can specify the protocol settings of the machine by using any of the following

software. Specify the settings using the easiest method.

• NetSpot Device Installer (Canon software included on the Network User Software

CD-ROM)

• NetSpot Console (via a web browser) (Canon software included on the Network

User Software CD-ROM)

• A web browser (Remote UI)

• An FTP client

Printer Protocol Settings

You can install NetSpot Console or NetSpot Device Installer from the Network User

Software CD-ROM provided with the machine, and use it to specify the protocol

settings on the computer you are using.

For instructions on how to install NetSpot Console or NetSpot Device Installer and

how to specify the protocol settings using NetSpot Console or NetSpot Device

Installer, see "NetSpot Console," on p. 5-3, or "NetSpot Device Installer," on p. 5-2,

respectively.

IMPORTANT

•

The machine's MAC address is necessary. To check the MAC address using the control

panel, follow the procedure below to perform a test print.

1. Press

(PRINT)

➞

(OK) on the control panel; the Online indicator goes

off.

2. Press (MENU) until <TEST MENU> appears.

3. Press (ITEM) until <PRINT EN CONFIG> appears in the second line of the

display.

4. Press (ENTER).

•

Check that the machine is connected to the network and that the machine's power is

turned ON.

NOTE

•

You can also ﬁnd online instructions on how to install NetSpot Console in the NetSpot

Console User's Guide or the Readme ﬁle, and how to set protocol settings in the NetSpot

Console User's Guide, Online Manual, or Online Help, all of which are included in the

NetSpot Console folder on the Network User Software CD-ROM provided with the

machine.