User Guide

Setting Up a Computer for Printing
3-10
Using a NetWare Network (Windows)
3
Setting Up a Computer for Printing
After you have completed NetWare print service settings and printer protocol
settings, you are ready to set up each of the computers for printing.
Connecting to a NetWare Network
In order to use a NetWare network, all computers that will perform printing need to
have NetWare client software installed. For details, see your NetWare and
operating system manuals.
Installing Printer Drivers
NetSpot Console or NetSpot Device Installer is software for specifying printer and
network settings.
Printing from a computer requires the installation of a printer driver. (See Chapter 1,
"Before You Start Using This Machine," in the PCL Driver Guide.) In the installation
procedure, select the network printer as the printer destination, and select the print
queue that you created in "NetWare Print Service Settings," on p. 3-3.
Setting the Printer Destination
1 On the [Start] menu, point to [Settings] ➞ click [Printers] ➞
right click the icon of the machine you will use for printing ➞
click [Properties].
2 Click the [Details] tab or the [Port] tab to display the [Details]
sheet or the [Port] sheet ➞ set the printer destination port to
the print queue you created in "NetWare Print Service
Settings," on p. 3-3.
3 Click [OK] to enable the settings.
NOTE
If you set up the printer destination when you installed the printer driver, this step is
not necessary.