Service manual

Chapter 7
7-26
F-7-75
7.6.8.11 Removing the Image
Processor PCB 0006-9735
1) Disconnect all connectors from the image
processor PCB [1].
2) Remove the 6 screws [2], and detach the image
processor PCB [1].
F-7-76
7.6.8.12 Removing the NCU
PCB (if equipped with fax
functions) 0006-9736
1) Disconnect all connectors form the NCU PCB [1].
2) Remove the 4 screws [2], and detach the NCU PCB
[1].
F-7-77
7.6.8.13 Removing the
Modular Jack PCB (if
equipped with fax functions) 0006-9738
1) Disconnect the connector [1].
2) Remove the screw [2], and detach the modular jack
PCB [3].
F-7-78
7.6.8.14 Removing the Main
Motor Unit 0006-9739
1) Remove the plastic film [1].
[3]
[2]
[2]
[1]
[2] [2][2]
[2]
[1]
[2]
[2]
[1]
[2]
[3]
[1]
[2]