Service manual

Chapter 9
9-10
9.3 Parts Replacement
Procedure
9.3.1 Control Panel
9.3.1.1 Removing the Control
Panel 0006-9478
1) Slide the reader unit, and open the cartridge cover.
2) Remove the screw [1], and slide the control panel
[2] to the left.
F-9-5
3) Close the cartridge cover.
4) Disconnect the connector [2], and detach the
control panel [1].
To prevent damage to the flexible cable, be sure to lift
the control panel slightly as shown when
disconnecting the connector [2].
F-9-6
MENO:
To mount the control panel, turn it over as shown in
below figure, and connect the connector [1]; then, turn
back over [2] the control panel to facilitate the work.
F-9-7
9.3.2 Analog Processor PCB
9.3.2.1 Removing the
Copyboard Glass 0007-7199
1) Open the ADF.
2) Remove the 2 screws [1], and detach the copyboard
glass retainer [2].
3) Remove the copyboard glass [3].
F-9-8
[1]
[2]
[2]
[1]
[1]
[2]
[1] [3]
[2]