Service manual

Chapter 9
9-18
F-9-39
9.3.8.4 Removing the DC
Controller PCB 0007-7201
1) Disconnect the 4 connectors [1] used to connect the
image processor PCB and the power supply unit.
2) Disconnect the connector [2] used to connect the
NCU PCB and the power supply unit.
3) Disconnect the connector [3], and free the harness
[4] from the harness guide [5].
F-9-40
4) Disconnect the 3 connectors [1].
F-9-41
5) Remove the cassette.
6) Place the machine so that its pickup side is at the
bottom.
F-9-42
7) Remove the 8 screws [1], and detach the bottom
plate [2].
F-9-43
8) Remove the 2 screws [1], and detach the cassette
[2]
[1]
[1]
[2]
[4][4] [5][3]
[1]
[1]
[1]
[1]
[2]
[1]