Service manual

Chapter 14
14-11
T-14-9
T-14-10
T-14-11
(2) Check to make sure that the other party is tuned on.
Cause: (1) The other party did not respond.
(2) The other party is out of order.
(3) The other party is out of use for some reason.
(4) The exchange is congested.
(5) There is no line/channel that is available at present.
(6) The requested line/channel cannot be used on the side of the other party.
(7) Calls crashed.
(8) Communication is not possible at present by reason of terminal
management.
Remedy: Ask the operator of the other party to find out the cause.
#021 [RX] The other party has rejected the machine during polling reception
Cause: When starting a call, a subaddress, or a subaddress and a password, was not
specified.
Remedy: Specify a subaddress, or a subaddress and a password, when starting a call.
#022 [TX] Call fails
Cause: The data for an auto-dial number used when selecting a party was deleted.
Remedy: Register the telephone number of the other party as an auto-dial number, and
transmit once again.
#025 [TX/RX] Auto-dial setting is wrong
Cause: The settings require registration of a subaddress for auto-dialing; however, a
call was attempted without registering a subaddress.
Remedy: If auto-dialing is of a type requiring registration of a subaddress, register a
subaddress.
#018 [TX] Auto dialing transmission error