Service manual

Chapter 15
15-59
MEMO:
The frequency and the output level of individual frequencies are in keeping with the output level set in service mode.
G3 Signal Transmission Test
A press on '4' on the keypad from the MODEM NCU Test menu selects the G3 signal transmission test. In this test,
the following G3 signals from the modem are transmitted using the telephone line terminal and the speaker. To select
a different transmission speed, use the keypad.
T-15-35
MEMO:
The output level of individual signals is in keeping with the setting made in service mode.
DTMF Signal Transmission Test
A press on '5' on the MODEM NCU Test menu selects the DTMF signal transmission test. In the test, the following
DTMF signals from the modem are transmitted using the telephone line terminal and the speaker. The number
pressed on the keypad selects a specific DTMF signal.
MEMO:
The output level of individual signals is in keeping with the setting made in service mode.
Tonal/DTMF Signal Reception Test
A press on '6' on the keypad from the MODEM NCU Test menu selects the tonal signal/DTMF signal reception 0
test. In this signal, the tonal signal/DTMF signal received from the telephone line terminal can be checked to find
out if it was detected by the modem.
Keypad Transmission speed
0 300 bps
1 2400 bps
2 4800 bps
3 7200 bps
4 9600 bps
5 TC7200 bps
6 TC9600 bps
7 12000 bps
8 14400 bps