Service manual

Chapter 2
2-2
2.2 Unpacking and
Installation
2.2.1 Before Starting
0006-3639
Go through the following before starting to install the
machine:
If the machine is moved from a cold to a warm place
for installation, condensation can develop in its
pickup/feeding assembly, causing image faults. To
avoid the condensation, leave the machine unpacked
for 1 hr or more so that it will be fully used to the room
temperature.
(The term condensation refers to the development of
drops of water on a mental surface when it is brought
from a cold to warm place. This occurs as a result of
rapid cooling of vapor in the air.)
2.2.2 Installation Procedure
0006-3652
Install the machine in the following order; for details,
see the appropriate sections that follow; after
installation, be sure to clean up the area around the
machine:
1. unpacking
2. fitting the cartridge
3. putting paper in the cassette
4. putting paper in the manual feed tray
5. connecting the interface cable (if equipped with
printer functions)
6. connecting the modular cable (if equipped with fax
functions)
7. connecting the power cord
8. fitting the delivery tray
9. checking the copy images
10. setting the printer function (if equipped with
printer functions)
11. setting the fax functions (if equipped with fax
functions)
2.2.3 Unpacking
0007-7166
1) Unpack the machine, and take out the attachments.
Check to see that none of the following is missing:
- cassette
- delivery tray
- cartridge
- power cord
- Quick Start Guide
- Reference Guide
- Fax Guide (if equipped with fax functions)
- CD-ROM (if equipped with printer functions)
- Modular cable (if equipped with fax functions)
- warranty card
- Distination label
2) Holding the grips on the left and right of the
machine, lift it out of the box.
3) Remove the packing material: plastic sheets,
securing members, and tape.
2.2.4 Fitting the Cartridge
0007-7188
1) Unpack the cartridge, and take it out without
removing its wrappings.
2) Rock the cartridge left and right about 5 to 6 times
to even out the toner inside.
F-2-2
3) Detach the tab and pull out the tape slowly. When
doing so, be sure to place the cartridge on a level
surface, and hold it firmly in place. However, take
care not to push down on the photosensitive drum
through the shutter.