User Guide

1
2
3
4
5
6
TOP
Back Previous Next
5-4
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
System Monitor
Reports and Lists
Troubleshooting
Appendix
Faxing Problems
■ Sending Problems
Cannot send a fax.
Q Is the machine overheated?
A Unplug the machine and let it cool for about 5
minutes. Then plug in the machine and try sending
again.
Q Did you just connect the power cord to the
machine?
A Wait for a while. After connecting the power cord,
the machine cannot scan documents immediately.
Q Is the machine set for the correct telephone line
type?
A Make sure the machine is set for the correct
telephone line type. (See “Set the Telephone Line
Type,” in the Starter Guide.)
Q
Is your machine in fax mode?
A Press [FAX] to show fax standby display.
Q Is the document loaded correctly?
A Make sure the document is correctly loaded. (See
Chapter 2, “Document Handling,” in the Basic
Guide.)
A Make sure the front cover is fully closed.
Q Is the one-touch speed dialing key or coded
dialing code you entered registered correctly?
A Check that the speed dialing settings are
registered correctly. (See Chapter 4, “Sending
Faxes,” in the Basic Guide.)