User Manual

10
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Setting Up the Scanner
Perform the following steps to set up the CR-135i/CR-190i. Refer to
the section for each step for details about that step.
1 Check your operating environment. (See “Checking Your
Operating Environment” on p. 11.)
2 Install the software. (See “Installing the Scanning Utility”
on p. 11.)
Install the Scanning Utility provided with the CR-135i/CR-190i.
3 Connect the scanner to a computer. (See “Connecting the
Scanner to a Computer” on p. 12.)
4 Turn ON the power. (See “Turning ON the Power” on
p. 13.)
5 Automatically installing the device driver. (See p. 14.)
The device driver is installed automatically when Windows
recognizes the CR-135i/CR-190i.
IMPORTANT
• To have the device drivers installed automatically when the
computer recognizes the CR-135i/CR-190i, the software needs to
be installed before the CR-135i/CR-190i is connected to the
computer.
• If you connect the computer and turn ON the CR-135i/CR-190i
before installing the software, the following wizard screen appears.
If this happens, click [Cancel], turn OFF the CR-135i/CR-190i, and
then install the software.
The following wizard screen is an example in Windows Vista. When
a similar wizard screen appears in Windows XP/7, click [Cancel].
Wizard Screen (Windows Vista)