User Guide (pdf)

16
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Perform the following steps to set up the CR-135i II/CR-190i II. Refer to
the section for each step for details about that step.
A Check your operating environment. (See “Checking Your
Operating Environment,” on p. 17.)
B Install the software. (See “Installing the Software,” on
p. 18.)
Install the Scanning Utility provided with the CR-135i II/CR-190i II.
C Connect the scanner to a computer. (See “Connecting
the Scanner to a Computer,” on p. 19.)
D Turn ON the power. (See “Turning ON the Power,” on
p. 20.)
E Automatically installing the device driver. (See p. 21.)
The device driver is installed automatically when Windows
recognizes the CR-135i II/CR-190i II.
IMPORTANT
• To have the device drivers installed automatically when the computer
recognizes the CR-135i II/CR-190i II, the software needs to be installed
before the CR-135i II/CR-190i II is connected to the computer.
• If you connect the computer and turn ON the CR-135i II/CR-190i II before
installing the software, the following wizard screen appears. If this
happens, click [Cancel], turn OFF the CR-135i II/CR-190i II, and then
install the software.
The following wizard screen is an example in Windows 7. When a similar
wizard screen appears in Windows 8.1/10, click [Cancel].
Setting Up the Scanner
Wizard Screen (Windows 7)